Free shipping on US orders over $50 · In-stock orders placed by noon ET ship the same day · 877-839-3531
Shop the store
Electronics

How to assemble the Fender American Vintage 62 Jazz Bass Wiring kit – Part 3

This is a continuation from part 2.

Below: Tinning the ground wire in preparation for soldering (the white wire later also will be tinned).

Below: Soldering the ground wire to the pot.

Below: Soldering the white wire to the upper left terminal.

Below: Coaxing the wire out of the ends of the cloth coating.

Below: Progress thus far. Potentiometer and output jack are connected.

Below: Potentiometer for the neck pickup.

Below: Tinning the end of the white signal wire for the neck pickup potentiometer.

Below: After white signal wire has been soldered, black wire is tinned and soldered to the potetiometer.

Below: Completed soldering for neck pickup potentiometer. All soldering is completed at this point.

Parts for this job

Shop all →

Next stepShop preamps and controlsIn stock parts ship the same day when ordered by noon ET.
Shop now

2 thoughts on “How to assemble the Fender American Vintage 62 Jazz Bass Wiring kit – Part 3”

  1. I thought the originals had a pair of resistors (220K?) coming from the output of both pots, so there wasn’t any interaction between the two sets of vol/tone. This way you could wind the tone all the way down on one pickup (for example) without it affecting the other pickup. Way more versatile. The downside being you had less output and clarity, due to the ‘mix’ resistors.

    Reply
  2. Adding resistors does make blending the pickups better, but they take the bite out your pickups. My bass sounded way punchier without them.

    Reply

Leave a comment

We only use your email if we need to reach you about your comment. Here's what else you should know:

  • Never publishedOnly your name shows with your comment. Your email stays with us.
  • No mailing listCommenting doesn't sign you up for anything. The newsletter is a separate opt-in.
  • A real person reads itEvery comment goes to the shop crew, the people who rewire and solder basses every week, and we answer the questions.
  • Spam-filteredEvery comment is screened by Akismet, so the threads stay useful.