Free shipping on US orders over $50 · In-stock orders usually ship within 1 business day · 877-839-3531
Shop the store
Articles

How to build a bass guitar – Neck pocket template fabrication part 4

At this point, we’re completing the back side of the neck pocket template, and then tidying up and completing it before putting the template to good use.

IMG_1662

Above: Gluing in more scrap pieces to finish the end of the template. This is done to complete the back side. While the front side looks fine, the back is incomplete, and this is the completion.

IMG_1664

Above: Clamps holding the glued pieces to ensure good bond

IMG_1668

Above: When glue is dried, the overhang from the new piece is trimmed to fit template correctly.

IMG_1669

Above: Squaring of the corners is done by hand and necessary since a square corner cannot be cut with a round router bit.

IMG_1671

Above: Test fit of neck into template with new pieces added in on bottom.

The neck pocket template is now done! Now we move on to the body blank in the next step…

Where are the rest of the build steps?
You can view them all here.

Next stepShop bass partsIn-stock parts usually ship within 1 business day.
Shop now

Leave a comment

We only use your email if we need to reach you about your comment. Here's what else you should know:

  • Never publishedOnly your name shows with your comment. Your email stays with us.
  • No mailing listCommenting doesn't sign you up for anything. The newsletter is a separate opt-in.
  • A real person reads itEvery comment goes to the shop crew, the people who rewire and solder basses every week, and we answer the questions.
  • Spam-filteredEvery comment is screened by Akismet, so the threads stay useful.