Free shipping on US orders over $50 · In-stock orders usually ship within 1 business day · 877-839-3531
Shop the store
Repair & Installation

How to build a bass guitar – Finalizing the body shape / Rough Sanding part 6

This is a continuation from part 5.

Below: Although the neck and the body look flush to each other, they are not (the body is sitting slightly proud of the neck). Shaping will be required to make sure these two pieces are flush to each other.

Below: Masking tape is applied to the neck as a safety so it is not scratched.

Below: Body leveling starts. A flat file is being used here.

Below: The leveling of the heel to the neck continues. Note how the tape saved the neck from being subjected to several small scratches.

Below: The two surfaces are now flush to each other.

At this point the rough sanding is completed using 80-grit sandpaper. Here are views of what is completed up to this point.

We’ll start with the upper horn and heel.

Next, the heel and lower horn:

Next, the treble side butt:

Next, the back of the body:

Next, the forearm cut view:

Next, the control cavity view:

Next, the lower horn from a front view:

Next, the upper horn from a front view:

Next, the front horn again, this time zoomed out:

Finally, the overall view from above:

Where are the rest of the build steps?
You can view them all here.

Parts for this job

Shop all →

Next stepShop tools and partsIn-stock parts usually ship within 1 business day.
Shop now

Leave a comment

We only use your email if we need to reach you about your comment. Here's what else you should know:

  • Never publishedOnly your name shows with your comment. Your email stays with us.
  • No mailing listCommenting doesn't sign you up for anything. The newsletter is a separate opt-in.
  • A real person reads itEvery comment goes to the shop crew, the people who rewire and solder basses every week, and we answer the questions.
  • Spam-filteredEvery comment is screened by Akismet, so the threads stay useful.