Pure Tone PTT1 Mono Jack Wiring and Dimensions

Pure Tone's sheet for the PTT1 mono output jack: which lug is tip and which is sleeve, a dimension drawing, and a side-by-side with a standard jack.

Pure Tone PTT1 mono jack wiring and dimension drawing
Pure Tone PTT1 mono jack wiring and dimension drawing
Standard jack vs Pure Tone jack contact points
Standard jack vs Pure Tone jack contact points

Download the PDF

Key specs

  • Wiring: Tip = positive (hot). Sleeve = ground.
  • Thread: 3/8-32 UNEF-2A. Barrel length 0.375" (9.53 mm).
  • Overall height 1.068" (27.13 mm). Widths 0.701" (17.82 mm) and 0.729" (18.52 mm).
  • 4 contact points (2 positive tabs, 2 ground tabs) against 1 on a standard jack. Pure Tone says this holds the plug firmly even after heavy use.

Every diagram, wire by wire

The PTT1 hookup and dimensions as text.

How to read these

  • Tip is positive (hot). Sleeve is ground.

Pure Tone PTT1 mono jack: how to wire it

Wire it like any mono jack: the hot output to the tip lug, ground to the sleeve lug.

You need: Pure Tone PTT1 mono jack.

Pure Tone PTT1 mono jack: how to wire itWire it like any mono jack: the hot output to the tip lug, ground to the sleeve lug. Wire numbers match the wire table.12Controlslast volume or toneHot outputGroundPTT1 jackTip lug (+)Sleeve lug (ground)Copper lines = signal. Ground symbol = solder to the back of a pot casing (the ground bus). Numbers match the wire table.
Pure Tone PTT1 mono jack: how to wire it, redrawn as a connection diagram. Original drawing: Pure Tone PTT1 sheet.
Pure Tone PTT1 mono jack: how to wire it: wire by wire
#FromToNotes
1Controls: Hot outputPTT1 jack: Tip lug (+)
2Controls: GroundPTT1 jack: Sleeve lug (ground)
PTT1 dimensions
MeasurementValue
Thread3/8-32 UNEF-2A
Barrel length0.375" (9.53 mm)
Overall height1.068" (27.13 mm)
Widths0.701" (17.82 mm) and 0.729" (18.52 mm)

Step by step

  1. Hot. Solder the hot output wire (from the volume or tone) to the tip lug.
  2. Ground. Solder the ground wire to the sleeve lug.
  3. Test. Plug in and check the output, then wiggle the cable: it should stay quiet.
  • It's a mono jack. Active basses that switch the battery through the jack's ring need a stereo jack instead.

Parts in this diagram

Pure Tone Mono Output Jack
As low as $4.20

FAQ

Which lug is hot on a Pure Tone mono jack?

The tip lug is positive (hot). The sleeve lug is ground.

Will it fit my bass?

Check the drawing: 3/8-32 thread, 0.375" barrel, 1.068" overall height.

Why use a Pure Tone jack?

It has 4 contact points instead of 1. Pure Tone says it holds the plug firmly even after heavy use.

Related diagrams

Questions about your install? Email sales@bestbassgear.com.