Other

Alpha 25k Volume Push/Pull Potentiometer
Alpha 25k Audio Taper Volume Push/Pull Potentiometer with 6mm Split Shaft For use with active pickups like EMG

Dual 25k Blend/Balance MN Taper Pot.Use with active pickups
Dual 25k Blend/Balance MN (linear) Taper Pot, with Center Detent and hardware. Use with active pickups, EMG...some others Technical Specifications: Threaded Bushing Diameter: ~.272" Threaded...

The GrooveTech kit provide everything you need to work on your bass, and an Easy Setup Guide is included that takes the mystery out of it.
Have tool kit; will travel. Bass players may know a little about truss rods and action, but few actually attempt adjustment. That's a shame, because a substantial upgrade in your performance can be realized with a properly set up axe. The GrooveTech kit...

Black Knob Set (Qty 3) Fits USA 1/4" (6.3mm) solid shaft pots. Can be stepped down to fit 6mm diameter solid or split shaft pots with brass pot sleeves, BBG 37.
Black Knob Set (Qty 3) With set screws for Jazz Bass, fits USA 1/4" (6.3mm) solid shaft pots.

The GrooveTech Jack and Pot Wrench provides three thin-wall sockets - 1/2", 7/16", and 12mm - in a compact four-inch tool to handle the most common sizes of jacks and pots on instruments, amps, and other audio gear.
Instrument and amp jacks are notorious for coming loose. And with a shallow nut and recessed cavity, access can be challenging. Until now, that is. The GrooveTech Jack and Pot Wrench provides three thin-wall sockets - 1/2", 7/16", and 12mm - in a compact...

Standard Driver provides firm contact over the entire slot width for damage-free adjustment.
Vintage-style truss rod nuts have very thin yet wide slots and are made of unhardened steel, so normal slotted screwdrivers will cause damage - as evidenced on many vintage guitars and basses. We developed two screwdrivers specifically for this application....

The Cheater Driver allows quick minor adjustment without removing the neck
Vintage-style truss rod nuts have very thin yet wide slots and are made of unhardened steel, so normal slotted screwdrivers will cause damage - as evidenced on many vintage guitars and basses. We developed two screwdrivers specifically for this application....

The first multi-tool for guitars and basses that's actually useful, without unnecessary gimmicks.
New Second Generation Design Introduced in 2008 - the original GrooveTech Multi-Tool was an instant hit with guitar and bass players alike. Never before had a multi-tool provided such functionality or made use of pro-grade components. Despite...

Vintage Cloth Push-Back Wire Set
Vintage Style Gavitt Cloth Covered Wire Set 2' Black & 2' White. 22 gauge tinned, Single Conductor, seven strand, Vintage Style, push back, cloth covered wire. Stranded wire with a waxed braided cotton outer insulation.